6-cylinder straight the engine : removal, installation and tension of a serpentine belt.

_____________________________________________________
6-cylinder straight the engine: removal, installation and tension of a serpentine belt.

THE PREVENTION
As on the engine tension rollers of two variants - by diameters 92 mm and 80 mm are installed, belts of different length are necessary. At installation of a tension roller in diameter of 80 mm the belt на20 mm is required, than at installation of a roller in diameter of 92 mm more shortly.
Removal
1. Remove a casing of the fan.
2. Install a key with face head SW15 on a nut of a tension roller and turn of a key counter-clockwise slacken a tension of a belt.
3. Remove a belt.

Fig. 1. Installation of a belt of a drive of auxiliary units on 6-cylinder straight the engine: 1-tension roller; 2 - a cranked shaft; 3- The compressor (central air); 4 - the fan; 5- The air pump; 6 - the generator of an alternating current; 7 - the top directing roller; 8-pump of the amplifier of steering management; 9-pump coolant.

Installation
4. Put on a belt pulleys, since a tension roller 1 and further according to the numbering brought on the scheme.
5. Slacken a tension roller turn of a key clockwise. Put on a belt completely.
6. Check up position of a belt on pulleys.
7. Insert a ring of a casing of the fan, turn and fix.


The information was given by beltdrive.50webs.com
_____________________________________________________